Danish loudspeakers

Danish designed loudspeakers with the latest technology ensure the Twist delivers on its promises: symmetric magnetic motor, solid aluminium basket, extensive venting, to name a few

Controlled directivity

By integrating the cabinet design, cross over and drivers, the Twist has a controlled directivity of sound, meaning the Twist is less critical to the listening room acoustics

Hand build in Denmark

Build by hand in the for Denmark typical small scale production adds a personal touch to each loudspeaker.

Select your veneer

Vist the Factory and be there during the build. You will be able to select the veneer you like best

Finely tuned cross over

the elaborate 24 dB/oct Linkwitz- Riley cross over gives more upper mid range energy for a more open sound and improves the tweeter high power performance.

Clean upper bass

The acoustic design of the cabinet effectively reduces internal standing waves around 200Hz for improved clarity

Danish Design

Carefully considered curves are the heart of each unique Davone design. The perfect rhythm and balance of the design visualize music.

the Magnetic Motor

All loudspeakers may look alike for the untrained eye. But to reduce cost, usually chassis are made from plastic, the magnet and voice coil are too small and the magnetic motor will be from simple, unoptimized geometry, to name a few. In contrast, take a look at the woofer that is used in the Twist that has been optimized for quality instead of cost:

The magnetic structure is optimised using advanced Finite Element Analysis software. The result is a magnetic field with a better than 95% symmetry within the voice coil travel range of +/-12 mm. Compared to traditional designs, the harmonic distortion is greatly reduced, especially at higher loudness levels

Large magnet structure with 39 mm heavy-duty fiber glass vented voice coil for better control, power handling, dynamic performance and low-level details

Copper cap on center pole to reduce voice coil inductance and to minimize variations in voice coil inductance as a function of voice coil position

Cone made of a paper/glass fiber mix with improved stability

Rigid die cast alu chassis with extensive venting for lower air flow speed reducing audible distortion

the making of the Twist baffle

The Twist panel is made from 10 layers HDF that is form pressed in shape. This gives a very stiff baflle.

Frequency response

38-22.000Hz

Impedance

4 ohm, 3.7 ohm minimum at 350Hz

Sensitivity

88 dB/2,83V/m

Recommended Amplifer power

100-200 Watt

Mid woofer

180mm, low distortion driver with a special fibre blend cone with optimal balance of stiffness, damping and density. Symmetric motor structure for optimal drive force symmetry. Designed in Denmark

Tweeter

1", Anodised aluminium dome, flow optimized vented pole piece with non-reflective chamber, saturation controlled motor system. Designed in Denmark
Cross over

2.4kHz, 24dB/Oct Linkwitz Riley

System

Bass reflex

Cabinet Construction

The twisted side panels are made from 7 layer beech wood form pressed veneer for increased stiffness and a unique appearance from all viewing angels. The form pressed baffle is made from 10 layers HDF

Weight

17.3 kg / piece

Height / Width / Depth

96 / 24 / 27 cm

Current version

HR

Designer

Paul Schenkel

Colours and materials

The Twist is available with fixed grille, or without grille. The fixed grille colour options are listed below. Without the grille, the front can be customised with almost any upholstery fabric of your choosing. Upholstery fabric offers a rich choice of thread colours and texture because it does not have to be sound transparent. But having many options also makes it difficult to choose. Therefore, below we list a small selection from the Danish Kvadrat Metric series we know suit the Twist very well.